Samson 12-STRAND Class II Whoopie Sling Modified for AmSt Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Outils Samson 12-STRAND Class II Whoopie Sling Modified for AmSt. Samson 12-STRAND Class II Whoopie Sling Modified for AmSteel and AmSteel-Blue User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
PAGE 1 OF 2
SamsonRope.com | Email [email protected] | Tel +1.360.384.4669
12-Strand Class II Whoopie Sling Modified for AmSteel
®
and AmSteel
®
-Blue
SAMSON SPLICING INSTRUCTIONS
1
step
Using these measurements do the Locked
Brummel Splice. Directions are as follows:
SPLICING FIXED EYE
AmSteel
®
and AmSteel
®
-Blue Whoopie Slings have a break strength of 60% of the published average rope break strength.
Note: For longer sling lengths, determine length needed beyond the maximum length listed in table to right. Multiply the length needed by two and add
resulting amount to cut length. For example: If you need a maximum length of 12 ft. on a 3/4 inch sling, this is 2 ft. longer than the listed max length. Multi-
ply 2 ft. x 2 = 4 ft. Add this to the original cut length (4 ft. + 24 ft. = 28 ft.). Your cut length will need to be 28 ft. to make a sling that adjusts to 12 ft.
All slings use the
same measurements
with proper size fid.
1A
Leave tail at full volume.
Just cut end at an angle,
then tape.
CUT LENGTHS FOR SLINGS:
1/2" 17-1/2' 5-1/2' to 8'
5/8" 20' 7' to 9'
3/4" 24' 7-1/2' to 10'
Rope Cut Sling Adjusts
Size Length From/To
Mark A Mark B
2 fids 1 fid
1/2 fid
fid short
section
1B
Pass end through
center of rope at Mark
B. Do not bury Mark A,
leave on entry side of
standing rope.
Mark A
Mark B
Mark A
Mark B
2 fids
Eye
1E
To bury the tail into the standing end, make a mark approximately 2 picks from where the standing
part passes through the tail (Mark C). This will be the tail entry point. From Mark C, measure down
the standing part 2-1/4 d lengths and make Mark D. Insert d and tapered tail at Mark C and bring
out at Mark D. Remove d and smooth the standing part out, which will bury the entire tail.
Mark D
2-1/4 fids
Mark C
(entry point)
1C
Pass the opposite
end through the
center of the tail
approximately
2 picks
from where
it exits the
standing rope.
1D
Close up
Brummel.
Pull
Pull
Pull
Pull
Vue de la page 0
1 2

Résumé du contenu

Page 1 - SPLICING FIXED EYE

PAGE 1 OF 2SamsonRope.com | Email [email protected] | Tel +1.360.384.466912-Strand Class II Whoopie Sling Modified for AmSteel®and AmSteel®-B

Page 2 - BACK SPLICING THE END

PAGE 2 OF 2SamsonRope.com | Email [email protected] | Tel +1.360.384.466912-Strand Class II Whoopie Sling Modified for AmSteel®and AmSteel®-B

Commentaires sur ces manuels

Pas de commentaire