Samson 1400 Instructions d'exploitation télécharger pdf (Page 77)

4

Out of specification

The positioner is operated outside the

specified operating conditions.

Note: If an event is assigned to the 'No mes

-

sage' status, this event does not have any ef

-

fect on the condensed state.

Condensed state

The condensed state appears on the display

with the following icons:

Condensed state

Positioner

display

Priority

Function check

Text, e.g.

TUNE

or

TEST

Failure

Out of specifica-

tion

blinking

Maintenance re-

quired/ Mainte-

nance demanded

The message with the highest priority deter

-

mines the condensed state in the positioner.

If error messages exist, the possible source

of error is displayed in Code 49 onwards. In

this case,

ERR

appears on the display.

Example:

Error caused by pin

position

The cause and recommended action are

listed in the code list (section 14).

Fault alarm output

The 'Failure' as the condensed state causes

the optional fault alarm output to be

switched.

4

The 'Function check' condensed state can

also activate the fault alarm contact in

Code 32.

4

The 'Maintenance required/ Mainte

-

nance demanded' condensed state and

'Out of specification' can also activate

the fault alarm contact in Code 33.

8.3.1 Confirming error messages

Enable configuration:

Note: If no settings are entered within

120 seconds, the enabled configuration

function becomes invalid.

Turn

®

Code 3, display:

No

Press , Code 3 blinks

Turn

®

YES

Press , display:

Confirm error messages:

Turn

®

Error code which you want to

confirm.

Press to confirm the error message.

EB 8384-6 EN 77

Operation

S

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 123 124

Commentaires sur ces manuels

Pas de commentaire