Samson 1400 Instructions d'exploitation télécharger pdf (Page 36)

Place the lever (1) in mid-position and

hold it in place. Screw on the nut (1.1).

5. Place the follower clamp (3) on the ac

tuator stem, align and fasten it, making

sure that the fastening screw rests in the

groove of the actuator stem.

6. Place the mounting plate (21) together

with the sensor onto the actuator yoke

so that the follower pin (2) rests on the

top of the follower clamp (3). It must

rest on it with spring force.

Screw tight the mounting plate (21)

onto the actuator yoke using both fixing

screws.

7. Mount cover (11) on the other side.

Make sure that the vent plug points

downwards when the control valve is

installed to allow any condensed water

that collects to drain off.

4.6.2 Mounting the position sen

sor with attachment accord

ing to IEC 60534-6

For the required mounting parts and acces

sories, refer to Table 7 on page 44.

1. Place the lever (1) on the sensor in

mid-position and hold it in place.

Unthread the nut (1.1) and remove the

lever together with the disk spring (1.2)

from the sensor shaft.

2. Screw the position sensor (20) onto the

bracket (21).

The standard attached lever M with the fol-

lower pin (2) at position 35 is designed for

120, 240 and 350 cm² actuators with

15 mm rated travel.

36 EB 8384-6 EN

Attachment to the control valve – Mounting parts and accessories

20 21

1.1, 1.2 14.1 3 14 99.1

Fig. 14 · Mounting according to IEC 60534-6 (NAMUR)

1 Lever

1.1 Nut

1.2 Disk spring

2 Follower pin

3 Follower plate

9 Stem connector

9.1 Bracket

14 Bolt

14.1 Screws

20 Position sensor

21 Bracket

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 123 124

Commentaires sur ces manuels

Pas de commentaire

Samson 1400 Instructions d'exploitation Page 36

Commentaires sur ces manuels

Produits connexes et manuels pour Amplificateurs audio Samson 1400